Technical information

PROGRAMMING
29
cc. To change the timing, press or then press
.
15 Blinks
dd. To change to YES or NO, press or then
press
.
NO Blinks
ee. To change to YES or NO, press or then
press
.
NO Blinks
ff. To change to YES or NO, press or then
press
.
NO Blinks
The display will show for 2 seconds:
Then the controller will go into “OFF” state.
NOTE: During programming key can be used to return to the previous screen (except at the steps h
and i, when it has different functions).
key is used to confirm the settings and advance to the next screen.
At any time, to bring the controller to “OFF” state, just pres the
(“ON/OFF”) button.
D.5. Parameter Programming
Note: All American Panel Corporation blast chillers are initially programmed at the factory. These settings may be
considered standard for AP40BC250-12, AP40BC250-2-12, BCCP-1, BCCP-2, and BCIP units. However, the customer
may change any of these settings as indicated by necessities.
Note: During the programming steps any delay longer than 20 seconds before pushing the next button will cause the
controller to revert to “OFF” state and the display will show OFF. TO AVOID THIS, THE FOLLOWING INSTRUCTIONS
SHOULD BE CAREFULLY REVIEWED AND THE DESIRED SETTINGS SHOULD BE DETERMINED BEFORE
PROCEEDING.
If the control panel goes to OFF state, programming mode will have to be restarted.
D.5.1. Parameter Programming For Automatic Mode
D.5.1.1. Soft Cycle – Automatic Mode
a. With the display reading "OFF", press
.
OFF
INITIAL PROGRAMMING
COMPLETE
INITIAL PROGRAMMING
NAFEM COMMUNICATION
NO
INITIAL PROGRAMMING
RECIPES?
NO
INITIAL PROGRAMMING
PRINT DURING CYCLE
NO
INITIAL PROGRAMMING
PRINT & SAVE EVENTS
EVERY 15 MIN