Technical information

PROGRAMMING
32
D.5.2. Parameter Programming Manual Mode
Note: All American Panel Corporation blast chillers are initially programmed at the factory. These settings may be
considered standard for AP40BC250-12, AP40BC250-2-12, BCCP-1, BCCP-2, and BCIP units. However, the customer
may change any of these settings as indicated by necessities.
Note: During the programming steps any delay longer than 20 seconds before pushing the next button will cause the
controller to revert to “OFF” state and the display will show OFF. TO AVOID THIS, THE FOLLOWING INSTRUCTIONS
SHOULD BE CAREFULLY REVIEWED AND THE DESIRED SETTINGS SHOULD BE DETERMINED BEFORE
PROCEEDING.
If the control panel goes to OFF state, programming mode will have to be restarted.
D.5.2.1. Soft Cycle – Manual Mode
i. With the display reading "OFF", press
.
j. Enter the password (see page 25), then press
.
After about 2 seconds the display will automatically change
to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
h. Press to program the manual mode. The "M" LED
will be steady "ON" and the 6 "CYCLE LED's" will all
blink.
l. Press . The LED for "SOFT" will be steady "ON".
m. To change the temperature, press or then
press
.
28 Blinks
n. To change the temperature, press or then
press
.
35 Blinks
o. To change the time, press or then press
.
01:30
Blinks
p. To change the temperature, press or then
press
.
35 Blinks
OFF
PARAM. PROGRAMMING
ENTER PASSWORD
***
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGRAMMING
MANUAL MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
HOLDING LOW TEMP
35 °F
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
TOTAL TIME
H 01:30 MIN
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
HIGH AIR TEMPERATURE
35 °F
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
LOW AIR TEMPERATURE
28 °F