Technical information

PROGRAMMING
34
w. To change the temperature, press or then
press
.
35 Blinks
x. To change the time, press or then press
.
01:00
Blinks
y. To change the temperature, press or then
press
.
35 Blinks
z. To change the temperature, press or then
press
.
42 Blinks
The display will show:
D.5.3. UV Light Cycle Programming
With the display reading "OFF", press
.
Enter the password (see page 25), then press .
After about 2 seconds the display will change to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
aa. Press the
button. The LED for "UV LIGHT" will be
steady "ON".
bb. To change the time, press or then press
.
00:30
Blinks
The display will show:
PARAM. PROGRAMMING
ENTER PASSWORD
***
OFF
PARAM. PROGRAMMING
MANUAL HARD CYCLE
PROGRAMMING COMPLETE
PARAM. PROGRAMMING
MANUAL HARD CYCLE
HOLDING HIGH TEMP.
42 °F
PARAM. PROGRAMMING
MANUAL HARD CYCLE
HOLDING LOW TEMP.
35 °F
PARAM. PROGRAMMING
MANUAL HARD CYCLE
TIME 2
H 01:00 MIN
PARAM. PROGRAMMING
MANUAL HARD CYCLE
HIGH AIR TEMP PART 2
35 °F
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGRAMMING
UV CYCLE
PROGRAMMING COMPLETE
PARAM. PROGRAMMING
UV CYCLE
CYCLE TIME
H 00:30 MIN