Full Product Manual

American Spa Owner’s Manual

LTR50001143, Rev. ZZ

Preparing for Your New Portable Spa

Opening the Front Door Panel for Electrical Hookup

The following electrical connections must be performed by a licensed electrical contractor. Unscrew

and remove the two corner panels on each side of the spa’s front door.

Reach in and pull the drain assembly through by a few inches. Carefully unscrew the black outer drain knob and

then unscrew and remove the front door panel.

Pictured to the right is the inside of the spa behind the

front door. The electrician now has access to connect

the spa for power. While the front door is off, refer

to page 10 for instructions on ensuring the plumbing

ttings are secure (but do not be tempted to over-

torque or over-tighten these ttings).

Pull the drain pipe through the front door panel, reattach the black outer drain knob and pull the drain

assembly back inside so that the knob is ush with the panel again. Reattach and screw panels back in. (Front

door rst, then corner panels)