Instructions / Assembly

3
LTR17000972_ASC, Rev. B 5/14/20
Prime the pump.
Turn on power to the spa.
When the spa is lled to the correct level, turn on the power at
the GFCI breaker. (Ensure that the 120V spas are connected to the
proper electrical outlet.)
4
5
Jets
Aux Warm Cool Light
(auxiliaire)
(chaud)
(froid)
(lumière)
Running the pumps helps the pumps prime.
After two minutes, the pump should prime. When it does, continue with the next step. If the
pump does not prime, follow the priming instructions on the next page.
For VS300 and 5100 systems:
Your spa will perform a self-diagnostic check
and go into priming mode, which is indicated by
message Pr on the control panel.
Do the following:
a. Press the JETS button to turn on the pump
and let it run for 10 seconds. The pump
should be running in low speed.
b. Press the JETS buttons again and let the
pump run in high speed for 10 seconds.
c. Press the JETS button again to turn off the
pump. The pump should be left off for 10 to
15 seconds.
d. Repeat steps a through c until water is owing
through all the jets and all air is removed from
the plumbing.
Prime the pump (NEO Systems).
The system will
enter the priming
mode. Priming
Mode will display
on the control panel.
In Priming Mode,
all devices such as
jets and lights are
operable. Jets can
be turned on and
off to help prime the
pump. The system
will exit Priming
Mode and go to the
Main display when
the RETURN button
is pressed, or after
four minutes of
inactivity.
Priming the NEO System