Use and Care Manual

2
Fill the spa.
Remove the cartridge from lter canister.
Soft water makes it impossible to maintain
the proper water chemistry and may cause
the water to foam, which will ultimately harm
thenishofthespaandvoidyourwarranty.
Afteryouremovethelter,removetheplastic
wrapper and soak it in water for 30 minutes
beforeyoureplaceit.Adryltercanallowair
intotheltrationsystem which cancausethe
pump to fail to prime.
If you have a skimmer like this:
Gripthelterbythehandleandunscrewitfrom
the canister. Never try to pull the lter cartridge
while the spa is running in low or high speed (i.e.,
anyspeed).
If you have a skimmer like this:
Remove the black skimmer cap and barrel, grip the
lterbythehandleandunscrewitfromthecanister.
If you have a skimmer like this:
Rotate and remove the black locking ring. Remove
the black skimmer cap and barrel, grip the lter
by the handle and unscrew it from the canister.
Replace and lock the locking ring and slide the
skimmer cap and barrel back in the canister.
Note: The skimmer cap and barrel were locked
in place at the factory to prevent damage during
shipment. It must be unlocked and replaced in
theltercanistersothatitcanoatwhenthespa
is lled.Ifyoudonot remove the capandbarrel,
yourspasltrationsystemwillnotperformasitwas
designed to.
Place a garden hose in the lter canister and ll
your spa. Always ll the spa through the lter
canister. Failure to do so may cause air to be trapped
intheltrationsystemandpreventthepumpsfrom
operating properly.
Fill the spa until water level is about six inches from
the top. If the water level is too low or too high, your
spa will not operate properly. Never ll your spa
with soft water.
Teleweir Mega
lter skimmer
• 75 square feet
ltration
• Smooth cap
Teleweir lter
skimmer
• 50 square feet
ltration
• Spoked cap
2
3