Installation Guide

2a
2b
730515-100 Rev. A
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE
AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
INSTALLATION INSTRUCTIONS
Ravenna Wall-Hung Semi-Pedestal Sink
1
Introduction: Thank you for selecting our products...products which have been the benchmarks of
fine quality for years. To help insure that the installation process will proceed smoothly, please read
these instructions carefully before you begin. Also, review the recommended tools and materials
list; carefully unpack and examine your new plumbing fixture.
7/16" Wrench
Channel Lock Pliers
Regular Screwdriver
Recommended Tools & Materials
Phillips Screwdriver
Pipe Wrench
Putty Knife
Drill
Saber Saw
Basin Wrench
Plumbers' Putty or
Caulking
Tubing Cutter
Tape
Measure
Hacksaw
Pencil
3/16 Dia. Drill
9/32 Dia. Drill
© American Standard Inc. 2003
Level
Install lavatory anchor screws leaving
1-5/8" threaded end exposed as illustrated.
1-5/8"
ANCHOR SCREW INSTALLATION
Anchor
Screw
Washer
Lavatory
Nut
Pedestal
Anchor Holes
Access
L
C
9-1/2"
(241mm)
3"
(76mm)
26-1/2"
(673mm)
21"
(533mm)
24-3/4"
(629mm)
32"
(813mm)
SUPPLIES
3/8" x 4"
HANGER
STUDS
DRYWALL
DOUBLE
2" X 8"
50 X 203mm
WOOD BRACE
FINISHED FLOOR
WASTE
*NOTE: for ease of installation and accessibility, it is recommended that straight stops with flex supply tubes be used.
As an alternative, if rigid supply risers are used, it is suggested to use angle stops in place of the straight stops.
Provide Rough-in: Install waste
pipe 21" (533mm) up from the
floor. Install the supplies at 24-
3/4" (629mm) up from finished
floor, spaced 1-1/2" (38mm) to
either side of centerline. Firmly
attach two 2" x 8" (50 x 203mm)
wood braces to wall studs.
Bottom of brace should be 26-1/2"
(673mm) up from floor and extend
a minimum of 6" (153mm) to
either side of waste. Complete
drywall installation (see figure 1).
SINK
ANCHOR
HOLES
SEMI-PEDESTAL/SHROUD
ANCHOR HOLES
Drill (2) 9/32" dia. (7mm) holes 32" up from finished floor, spaced at 4-
3/4" (120.6mm) either side of centerline. Install (2) 3/8" x 4" lg studs
using the double nut method, leaving 1-5/8" of threaded end exposed.
Mount the sink to studs temporarily, making sure the sink is level side
to side.
Position semi-pedestal under bottom lip of sink. While
holding semi-pedestal in position reach through the access
area between the lavatory and semi-pedestal and mark the
location of anchor holes. Remove semi-pedestal and
predrill 3/16" (4-5mm) dia. holes at locations marked. Install
1/4" x 3" lg studs leaving 1-1/4" exposed. Use same anchor
screw installation as in 2a.
9/16" Wrench