Installation Guide

730515-100 Rev. A
AMERICAN STANDARD ONE-YEAR LIMITED WARRANTY
If inspection of this American Standard plumbing product, within one year after its initial installation, confirms that it is defective in
materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.
This limited warranty does not apply to local building code compliance; since local building codes vary considerably, the purchaser of
this product should check with a local building or plumbing contractor to insure local code compliance before installation.
This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty
maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American Standard's instructions; or if it has
been modified in a manner inconsistent with the product as shipped by American Standard.
American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal or
installation, nor shall American Standard be responsible for any other incidental or consequential damages attributable to a product
defect or to the repair or exchange of a defective product, all of which are expressly excluded from this warranty. (Some states or
provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to
province, in which case this warranty does not affect such statutory rights.
For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product
was purchased, or that a service request (including a description of the product model and of the defect) be sent to the following address:
In the United States:
American Standard, Inc.
One Centennial Ave.
Piscataway, New Jersey 08855
Attention: Director of Consumer Affairs
Toll Free: [phone]
In Canada:
American Standard, Inc.
2480 Stanfield Rd.,
Mississauga, Ontario
Canada L4Y 1S2
Toll Free: [phone]
In Mexico:
Customer Service Manager
American Standard, Inc.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
3 5
4
Remove lavatory top. Install faucet and pop-up assembly
("A") according to manufacturer's instructions before
installing sink. Remount sink on the threaded end of wall
studs. Firm up with washers and nuts, but do not over-
tighten. It may be necessary to cut off part of the tailpiece
(area "B") or part of the horizontal leg of the trap (area "C").
Connect water supplies lines and drain pipe
connections. Turn water on and check for leaks.
If installing optional towel bar (model 3520) it is recommended to install
the towel bar after the sink and semi-pedestal are installed. (See
instructions for towel bar.)
Through the access space between pedestal and
lavatory use a 7/16" wrench to tighten the pedestal
to wall.
Mount Semi-Pedestal in position on threaded end
of 1/4" studs using washers and nuts supplied.
A
B
C
7
6
Shut-Off Valves
Flex
Supplies
Drain
Connections
Illustration shown less
wall supplies.
Mounting
Studs
Access space