Installation Guide

2
7302307-100 Rev.A (10/20)
5
1-7/8"
ANCHOR SCREW INSTALLATION
Anchor
Screw
Washer
Lavatory
Nut
IMPORTANT: Final assembly of nut and washer or lag bolt method shown for reference only.
6
A
9
Rear
View
7
B
C
Note: Space constraints
may dictate method of
fastening pedestal to oor.
4
Remove lavatory and
pedestal from installed
position. Drill pilot holes for
lavatory and pedestal
anchor screws or lag bolts.
Note: Some models are supplied with lag bolts, anchor screws,
or steel hangers for lavatory installations only. Other models and
all pedestals are not provided with mounting hardware. Various
pedestal screw sizes and types are available to the installer at
local hardware outlets.
1
Provide suitable reinforcement
behind nished wall for lavatory
mounting screws.
*
Determine horizontal center line
location of support from xture.
NOTE: If replacing an existing sink
be certain to shut off water supply
before removing old sink.
C/L of 2X6
Support
Finished
Floor
*
3
Mark lavatory and pedestal screw locations through
the mounting holes.
2
Top of Pedestal
For example only
Place lavatory and pedestal into installed position.
Level and square the lavatory and pedestal
8
Secure lavatory to wall as
shown in Step 5. Install
washers and hand tighten
nuts or lag bolts. Level and
square the unit. Connect hot
and cold supply lines to the
shut-off valves. Tighten trap
joints for watertight assembly.
Following manufacturer's
instructions, install faucet and
drain assembly (not included).
Be certain to apply a bead of
sealing putty on the underside
of the drain (area "A") in order
to ensure a watertight seal
between the lavatory and
drain. Remove excess putty
after installing drain on
lavatory.
Return the tted lavatory to the
installed position. Connect trap to
drain assembly hand tight to
check alignment. It may be
necessary to cut off part of the
tailpiece (area "B") or part of the
horizontal leg of the trap (area
Lavatory slab
Install lavatory anchor screws leaving 1-7/8"
threaded end exposed as illustrated.
Shut-Off
Valves
Use lag bolts to secure lavatory as illustrated.
LAG BOLT INSTALLATION
Lag
Bolt
Washer
Lavatory
Lavatory
Steel
Hanger
ALTERNATE METHOD: COMPONENTS NOT INCLUDED