Installation Sheet

In the United States:
American Standard Brands
1 Centennial Ave.
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.americanstandard.com
In Canada:
AS Canada, ULC
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: [phone]
www.americanstandard.ca
In Mexico:
American Standard B&K Mexico
S. de R.L. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 01-800-839-1200
www.americanstandard.com.mx
7302242-100 Rev. A
4
CONSOLE CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotton flannel cloth.
DO NOT: Clean with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with coarse surface.
AMERICAN STANDARD ONE-YEAR LIMITED WARRANTY
If inspection of this American Standard plumbing product, within one year after its initial purchase, confirms that it is defective in
materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.
This warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of
this product should check with a local building or plumbing contractor to insure local code compliance before installation.
This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty
maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American Standard's
instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.
American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of
removal or installation, nor shall American Standard be responsible for any other incidental or consequential damages
attributable to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded
from this warranty. (Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion
may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to
province, in which case this warranty does not affect such statutory rights.
For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the
product was purchased, or that a service request (including a description of the product model and of the defect) be sent to the
following address:
B
C
4
5
Sink and Pedestal/Console Installation
1. Secure sink to wall, install washers and hand tighten nuts.
2. Connect hot and cold supply lines between the tting valve and the supply shut-off valves.
3. Tighten trap joints for watertight assembly.
4. Apply a bead of caulk around the back edge of the sink where it contacts the wall.
Note: For sink and console assembly, insert rectangular glass shelf onto the shelf support and
remove protective lm from glass shelf.
1. Following manufacturer’s instructions, install faucet and drain assembly
(not included).
2. Apply a bead of sealing putty on the underside of the drain (see detail A)
in order to ensure a watertight seal between the sink and the drain.
Remove excess putty after installing drain on sink.
3. Return the sink assembly to the installed position, guiding the sink over
the two headless hanger screws.
4. Connect the trap to drain assembly and hand-tighten to check alignment.
It may be necessary to cut off part of the tailpiece (see detail B) or part
of the horizontal leg of the trap (see detail C).
Faucet and Drain Installation
A