Dimensions Guide

ManualsBrandsAmerican Standard ManualsBathPiazza Bone Drop-In Oval Bathroom Sink with Overflow

J36

31"

(787mm)

SUGGESTED

33-1/4"

(845mm)

(178mm)

18-3/8"

(467mm)

23-1/2"

(597mm)

FINISHED WALL

OR SPLASHBACK

1-1/4" O.D. TAILPIECE

1-1/4" O.D. WASTE

FINISHED FLOOR

*10-3/4"

(273mm)

*12-7/8"

(327mm)

COUNTERTOP

(BY OTHERS)

SEALING

COMPOUND

3/4"

(19mm)

7-3/4"

(197mm)

OPTIONAL

SUPPLIES

AS REQ'D

2-3/4"

(70mm)

(203mm)

845mm

(33-1/4)

51mm

(2)

610mm

(24)

152mm

(6)

MAX.

BARRIER FREE

CLEARANCE

686mm

(27)

MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR

DIMENSIONAL

PURPOSES ONLY.

IT IS NOT AN EXACT

REPRESENTATION.

PIAZZA™

COUNTERTOP SINK

VITREOUS CHINA

BARRIER FREE

PIAZZA™ COUNTERTOP SINK

• Made from vitreous china

• Self-rimming with cutout template supplied

• Large faucet deck and generous bowl

• Front over ow

❏ 0478.403 Faucet holes on 4" (203mm) centers

❏ 0478.803 Faucet holes on 8" (102mm) centers

(illustrated)

❏ 0478.001 center hole only

Nominal Dimensions:

23-1/2" x 18-3/8"

(597 x 467mm)

Bowl sizes:

18-1/2" (470mm) wide

11-3/4" (299mm) front to back

6-1/2" (165mm) deep

Compliance Certi cations -

Meets or Exceeds the

Following Speci cations:

• ASME A112.19.2M for

Vitreous China Fixtures

• CAN/CSA B45 series

To Be Speci ed:

❏ Color:

❏ Faucet*:

❏ Faucet Finish:

❏ Supplies:

❏ 1-1/4" Trap:

* See faucet section for additional models available

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES

AND ANSI A117.1 ACCESSIBLE AND USABLE

BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor.

Lavatory installed 51mm (2") minimum from front edge

of countertop provides 686mm (27") knee clearance.

Revised 5/06

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE

SUGGESTED.

FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE

TEMPLATE SUPPLIED WITH SINK.

FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED

SEPARATELY.

SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT: Dimensions of  xtures are nominal and may vary within the range

of tolerances established by ANSI Standard A112.19.2. These measurements

are subject to change or cancellation. No responsibility is assumed for use of

superseded or voided pages.