Installation Instructions

730431-100 Rev. E
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
INSTALLATION INSTRUCTIONS
Undercounter Sink
Oval Shaped Models: 0495, 0496, 0497, 0630, 0632
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help
insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review the
recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
!
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2012
Recommended Tools & Materials
Observe Local Plumbing and Building Codes.
Adjustable Wrench Channel Lock Pliers
Regular Screwdriver
Phillips Screwdriver
10'
Pipe Wrench
Putty Knife
Silicone Adhesive
Basin Wrench
Plumbers' Putty
Tubing Cutter
Tape Measure
Hacksaw
Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.
Corian
®
Dupont registered trademark
Saber Saw
1 2
3
4
Perimeter of sink
Cutout
NOTE: More specialized tools may be necessary to install this sink to
countertop materials other than wood or wood composites.
NOTE: To avoid damage to
countertop, install sink such that
future removal from underneath
the countertop is possible.
First, make sure the clearance
between the backsplash, faucet,
fixtures and cabinets are acceptable
for the new sink.
Carefully cut out the enclosed
template, then position and trace
the template on the countertop as
shown on the template. Make a
mark of the faucet hole centerline
on the countertop. Drill a 1/2" pilot
hole on the inside of the cut line.
Use a saber saw or a keyhole saw
to cut out the countertop opening.
Drill
3/4" (19mm) MIN.
3/4" (19mm) MIN.
Drill 1/8" dia. X 3/8" deep
#10 Wood Screw
Clip
Mark and pre-drill the wood screw holes as located on the enclosed
template. Waterproof any exposed areas of wood.
Clip
Brass insert, epoxy
in place with threaded
end exposed.
(Epoxy not supplied).
#10-24 Mach. screw
FOR WOOD COUNTERTOP
FOR MARBLE OR SOLID SURFACE COUNTERTOP
To protect countertop, place it on a foam padding and drill
3/8 Dia. X 1/2 deep hole as per location shown on template.