Operating Guide

© 2003 American Standard Inc.
BS-16
TOWN SQUARE™ 24”
PEDESTAL SINK
FIRECLAY
TOWN SQUARE 24” PEDESTAL SINK
• Historic American classic design
• Clean straight lines with classic ogee curves
• Rear overflow
• Supplied with mounting kit
• Design-matched to Town Square fixture and
faucets
• Right Height™ for greater comfort during use
• Made from fireclay
❏ 0790.400 Faucet holes on 4” (102mm) centers
❏ 0790.800 Faucet holes on 8” (203mm) centers
❏ 0790.100 Center hole only
Nominal Dimensions:
24" x 20-1/4" x 35-1/2" (610 x 514 x 902mm)
Separate Components:
❏ 0790.004 Pedestal top 4” (102mm) centers
❏ 0790.008 Pedestal top 8” (203mm) centers
❏ 0790.001 Center hole only
❏ 0031.000 Pedestal only
Bowl sizes:
14” (356mm) wide,
11-3/4” (298mm) front to back,
6-1/2” (165mm) deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.9M for Non-Vitreous Ceramic
• CAN/CSA B45 Series
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE SUGGESTED.
■ FOR REINFORCEMENT ONLY. TAKE ACTUAL DIMENSIONS FROM FIXTURE.
SLAB/PEDESTAL ANCHORS AND MOUNTING FEATURES TO BE FURNISHED BY OTHERS.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances
established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility is assumed for
use of superseded or voided pages.
* See faucet section for additional models available
1-1/4" O.D.
WASTE
★ 24"
(610mm)
★ 22"
(559mm)
SUPPLIES AS
REQUIRED
6"
(152mm)
DRAIN
CHASE
OPEN
TO
FLOOR
9-1/2"
(241mm)
20-1/4"
(514mm)
24"
(610mm)
FINISHED WALL
FINISHED
FLOOR
1-3/4" DIA.
STD. DRAIN
OUTLET
18-3/4" (476mm)
2-5/8"
(67mm)
4"
(102mm)
4"
(102mm)
5/8"
(16mm)
PED BASE
OUTLINE
PED TOP
OUTLINE
35-1/2"
(902mm)
28"
(711mm)
3-3/4" (95mm)
7-1/2"
(191mm)
6"
(152mm)
10"
(254mm)
3/8" (10mm) DIA.
BASE ANCHOR
SCREW HOLES
ON 6" (152mm)
CTRS
3/8" (10mm) DIA.
SLAB ANCHOR
SCREW HOLES
ON 18-3/4" (476mm)
CTRS
M
M
Revised 10/02
To Be Specified
❏ Color:
❏ Town Square Faucet:
❏ Centerset Lavatory Faucet: 2555.201 (shown)
❏ Widespread Lavatory Faucet: 2555.801
❏ Other Lavatory Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap: