Installation Guide

Minimalist

VESSEL LAVATORY FITTING

Installation

Instructions

M968858 Rev.1.5

Certiﬁed to comply with ANSI A112.18.1M

2064 Series

Turn off hot and cold water

supplies before beginning.

CAUTION

Adjustable Wrench

Channel Locks

Regular Screwdriver

Phillips Screwdriver

Plumbers' Putty or Caulking

INSTALL LAVATORY FAUCET

Seat SEAL (1) into under side of ESCUTCHEON RING (2).

Feed FAUCET SUPPLIES (3) and MOUNTING SHANK (4) through

ESCUTCHEON RING (2) and hole in mounting surface.

Seat ESCUTCHEON RING (2) with collar facing up into groove

in faucet base.

From below, install SUPPORT PLATE (7) GASKET (5) and MOUNTING

NUT (6) onto SHANK (4). Secure Faucet with MOUNTING NUT (6).

Before ﬁnal tightening, adjust Faucet so that it is centered. Tighten

MOUNTING NUT (7) to complete mounting.

Note: For thick deck installations, the SUPPORT PLATE (7) can be omitted.

Recommended Tools

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A

CLOTH WITH A COARSE SURFACE.

MOUNTING SURFACE

COLLAR

GROOVE

(FAUCET BASE)

PAGE 1
Installation Instructions Minimalist 2064 Series VESSEL LAVATORY FITTING Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M 9 6 8 8 5 8 R e v. 1 .
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot and right supply to the Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 10" 1 HOT COLD Faucet supplies are 10" long from faucet base. Note: If additional supply length is required, installer must purchase additional parts separately.
PAGE 3
4 TEST INSTALLED FAUCET AND CHECK FOR LEAKS OFF 1 ON HOT With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. COLD Remove AERATOR (3). Operate HANDLE (1) to flush water lines thoroughly. 3 Replace AERATOR (3). HOT COLD 2 5 SERVICE CAUTION Turn off hot and cold water supplies before beginning. To remove or replace cartridge Turn valve to OFF position. Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2). Pull off HANDLE (3) and CAP (4).