Specification

FINISHED FLOOR

APPLY SEALANT

• Move HANDLE (23) onto “off” position and remove STREAM

STRAIGHTENER (24) with KEY (25) supplied.

• Turn on water supplies and check all connections for leaks.

Check MANIFOLD (26) connections for leaks.

• Apply sealant to underside edge of ESCUTCHEON (27). Slide

ESCUTCHEON (27) down to nished oor. Press into place.

Clean up excess sealant.

• Operate HANDLE (23) On to Off and Hot to Cold to ush water

lines thoroughly.

• Lift HAND SHOWER (21) from the HOLDER (22) and direct spray into

tub. Rotate DIVERTER KNOB (28) and check HAND SHOWER (21)

and SPRAY HOSE (19) connections for leaks.

• Rotate DIVERTER KNOB (28) back and place HAND SHOWER (21)

into HOLDER (22).

• Re-install STREAM STRAIGHTENER (24).

TEST INSTALLED FAUCET

7 1

• Align slot in RETAINING RING (13) with SET SCREW HOLE (14) in SPOUT (15).

Install SPOUT (15) onto FAUCET BASE (16). Align SPOUT (15) with bath and

tighten SET SCREW (17). (VIEW “B”)

• Install SEALS (18) on both ends of the SPRAY HOSE (19). Connect the end with

the hex to the DIVERTER (20) using an adjustable wrench. Hand tighten the

connection to the HAND SHOWER (21).

Note: When not in use, the HAND SHOWER (21) should

be seated in the SHOWER HOLDER (22).

INSTALL SPOUT AND HAND SHOWER

(VIEW “B”)

M965638 REV. 1.3 (10/15)