Installation Guide

1
4
1. Remove COVER from CONTROL BOX (1).
2. Disconnect BATTERY HOLDER (3) from 27"
EXTENSION CABLE (5).
3. Remove old BATTERY from BATTERY HOLDER (3).
Install new BATTERY (2) making sure the terminal side
is inserted first and shape of the battery follows the shape
of the BATTERY HOLDER (3).
4. To replace LONG LIFE POWER PACK (4), unplug and
replace with new Power Pack.
5. Reconnect BATTERY HOLDER (3) to 27" EXTENSION
CABLE (5).
6. Replace CONTROL BOX COVER. Tighten cover screws
firmly.
Fig. 4
3
8
M965653 Rev. 1.4 (10/15)
FAQ'S
Q: How will I know if the battery needs to be replaced?
A: Valve will not open and sensor will continuously blink 2 times interrupted by a pause for up to 7 days.
Q: Why has the flow rate of the faucet reduced significantly?
A: The filter assembly, flow regulator or areator/spray may be clogged. Check and clean. Refer to Start-up/Maintenance,
sections C, D and E.
Q: Why doesn’t the water flow out of faucet when I'm within the sensor detection zone?
A: Battery may need replacement. Check. If sensor continuously blinks 2 times interrupted by pause, replace battery
or call (844) CRT-TEAM / [phone].
Q: What is the normal operating pressure range?
A: Faucet will operate with supply pressures ranging from 20-80 psi.
INSTALL / REPLACE THE BATTERY or
LONG LIFE POWER PACK; Fig. 4
D
1. Remove AERATOR HOUSING (1) with KEY supplied
with faucet.
3. Remove AERATOR (2) from HOUSING (1).
2. Clean the AERATOR SCREENS (3).
4. Clean with water. Reassemble and install into
spout end. Make sure black seal washer is in place.
CLEAN AND REMOVE
THE AERATOR; Fig. 5
E
Fig. 6
CAUTION
GENERAL CLEANING; Fig. 6
1. For general cleaning use a damp, soft cloth to clean
the spout and the sensor.
2. For cleaning dirt use a soft cloth with diluted dish
washing detergent. Wipe the area using a wet cloth
and dry using a soft cloth.
Do not scratch the sensor when cleaning.
Avoid using anything that may scratch the spout
surface. Never use polishing power, detergent or a nylon
scrub brush. They will damage the surface of the spout or
Sensor.
F
2
3
Fig.5
1
CR-P2
6
3
2
STANDARD
BATTERY
LONG LIFE
POWER PACK
5