Installation Guide

754749-100
3
INSTALLATION AND FRAMING INSTRUCTIONS:
A.) Locate studs as required. Ensure roughing-in dimensions are proper, plumb, and square. It is strongly recommended that
an additional opening be provided for access to the drain components.
B.) As shown in ILL. 2, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
C.) With the top of the stringer touching the traced line, attach the stringer to the studs.
D.) Install drain components to the bath following the manufacturer's instructions. See the roughing-in drawing for
suggested opening size and location dimensions.
1
16-3/4"
(425mm)
Each alcove
stud must
be plumb
and square.
30
"
(762mm)
ILLUSTRATION 1
ILLUSTRATION 2