Installation Guide

ManualsBrandsAmerican Standard ManualsBathColony Universal 1.28 or 1.6 GPF Elongated Toilet Bowl Only in White

RECOMMENDED TOOLS AND MATERIALS

Putty Knife Regular Screwdriver Adjustable Wrench Sealant Tape Measure

Hacksaw Wax Ring/Gasket Flexible Supply Tube Closet Bolts Carpenters Level

1 REMOVE OLD TOILET

a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.

NOTE: Mounting surface must be clean and level before new toilet is installed!

SAVE FOR FUTURE USE

7302073-100 Rev. A

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

Product names listed herein are trademarks of AS America Inc.

NOTE: Pictures may not exactly define contour of china and components.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed

properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be

sure your installation conforms to local codes.

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

Colony

Two-Piece Toilet

221AA/221AB Series Colony Right Height

Elongated

221CA/221CB Series Colony Elongated

221DA/221DB Series Colony Round Front

ROUGHING-IN DIMENSIONS:

NOTE: Distance from wall to closet flange centerline must be as listed on chart under ROUGH-IN DIMENSION “A”,

the BOWL HEIGHT is listed as DIMENSION “B”.

BOWL SHAPE

RIGHT HEIGHT

12" (305mm) 16-1/2" (419mm) 221AA 3251A 4192A

ELONGATED 10" (254mm) 16-1/2" (419mm) 221AB 3251A 4192B

ELONGATED 12" (305mm) 15" (381mm) 221CA 3251C 4192A

10" (254mm) 15" (381mm) 221CB 3251C 4192B

ROUND FRONT 12" (305mm) 15" (381mm) 221DA 3251D 4192A

10" (254mm) 15" (381mm) 221DB 3251D 4192B

ROUGH-IN

DIM. “A”

COMBO

MODEL

BOWL

MODEL

TANK

MODEL

BOWL HEIGHT

DIM. “B”

FINISHED WALL

FINISHED FLOOR

SUPPLY

REQ'D.

B B

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS CARE AND MAINTENANCE Colony® Two-Piece Toilet 221AA/221AB Series Colony Right Height® Elongated 221CA/221CB Series Colony Elongated 221DA/221DB Series Colony Round Front Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
PAGE 2
3 4 5 NUT WAX RING SEALANT CLOSET FLANGE TAPERED WASHER A CLOSET BOLT CLOSET BOLTS FLANGE INSTALL WAX SEAL Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around toilet base. INSTALL CLOSET BOLTS Install closet bolts in flange channel and slide into place parallel to wall. 6 POSITION TOILET ON FLANGE a.
PAGE 3
9 ! A Connect water supply line. (Sold separately) Hand tighten nut. B WARNING: Overtightening of water supply line nuts could result in breakage and potential flooding. If the connection leaks after hand tightening, replace the supply line. Do not use any type of sealant on the water supply connection. Use of plumber’s putty, pipe dope, or any other type of sealant will void the warranty. Turn on water supply.
PAGE 4
CARE AND CLEANING When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth. WARNING: Do not use in-tank cleaners. These products can seriously corrode fittings in the tank. This damage can cause leakage and property damage. American Standard shall not be responsible or liable for any damage caused by the use of in-tank cleaners. TROUBLESHOOTING GUIDE - See Step 8 For Diagram Problem Possible Cause Does not flush a. Water supply valve closed.