Installation Guide

754818-100 Rev. A
11
OWNER’S MANUAL
Tubs installed in an alcove installation require a raised flange to prevent water from seeping past the tub and into the wall.
Tubs without a raised flange shall be installed with a tile flange kit such as model: 9FLNG or a similar type. The flange kit
is a long plastic strip that fits onto the rim of the tub to provide the leak protection needed.
The tile flange should be installed on the tub before it is placed in the alcove. Install the tile flange along all sides of the
tub where the wall will be. Measure to fit and miter cut the flange corners. The flange should be attached to the tub with
a silicone adhesive.
Warning: Never attempt to nail or screw thru the tub as this will result in product failure and will void the warranty.
ALCOVE INSTALLATION
52"
(1321mm)
40"
(1016mm)
13"
(330mm)
16-1/2"
(419mm)
30"
(762mm)
ROUGH FLOOR
WALL
STUD
GALVANIZED
NAIL
TILE
FLANGE
NON-INTEGRAL FLANGE
TUB
SILICONE
TILE
DRY
WALL