Installation Guide

754818-100 Rev. A
13
OWNER’S MANUAL
The Acrylic Extension Kit is designed to accommodate all acrylic walk-in tubs to fit within a 60" alcove
pocket. The top panel measures 30" x 20" (depth x width) and the front panel 37-1/2" x 20" (height x width).
The panels must be trim to fit the unit within the 60” alcove.
Step 1
• Temporary locate the tub within the alcove walls.
• Level the tub along the deck and apron.
• Measure and record the distance from the tub and apron to the adjacent alcove wall.
Step 2, 3 & 4
• Mask off and mark the trim lines for the top and front extension panels.
• Using a high speed carbide tooth blade, cut along the trim lines
• Mark a horizontal line that is parallel to the tub’s deck along the back and adjacent wall of the alcove.
• Mark a vertical line that is parallel to tub’s apron on the adjacent wall of the alcove.
• Install three wood stringers approximately 3/8" below the horizontal and vertical lines.
• Verify the fit of the front panel and then the top panel to the alcove opening.
• Shimming may be required to achieve a level fit.
ACRYLIC EXTENSION KIT INSTALLATION
Draw cut line
accordingly to
measured distance
Place wood stringers
3/8" below top deck
and 3/8" away from
end of alcove wall
Cut panels
along line
Top Panel
Front Panel
Self Tapping Screw
EXTENSION KIT PARTS
Measure
Distance