Dimensions Guide

H141
© 2009 AS America Inc.
Revised 3/02
ALCOVE SHOWER BASE
Product Features:
• Acrylic with berglass reinforcement
• Single threshold unit
• Textured bottom pattern
• Integral self-leveling base
• Integral three-sided, double tiling edge
with water retention ange
• Molded-in ood guard
• PVC shower drain with stainless steel
drain plate
❏ 4242.ST ALCOVE SHOWER BASE
Nominal Dimensions:
1070 x 1070 x 168mm
(42-1/8" x 42-1/8" x 6-5/8")
❏ 3636.ST ALCOVE SHOWER BASE
Nominal Dimensions:
914 x 919 x 168mm
(36" x 36-3/16" x 6-5/8")
❏ 3232.ST ALCOVE SHOWER BASE
Nominal Dimensions:
813 x 813 x 168mm
(32" x 32" x 6-5/8")
Does not meet IAPMO minimum inside square inch
requirements of 1,024 square inches.
Compliance Certications -
Meets or Exceeds the Following Specications:
• ANSI Z124.2 for Plastic Shower
• ASTM E162 for Surface Flammability
• NFPA 258 for Smoke Density
To Be Specied - Required:
❏ Color: (specify color)
To Be Specied - Optional:
❏ Metal Drain Plate:
 ❏ 751819-099 in Polished Brass
or
 ❏ 751819-295 in Satin Nickel
ALCOVE
SHOWER BASE
HIGH GLOSS ACRYLIC
NOTES:
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH SHOWER
BASE FOR ADDITIONAL INFORMATION.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard Z124.1 / CSA. These
measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.
SEE REVERSE SIDE FOR ROUGHING-IN DIMENSIONS
AND PRODUCT SPECIFICATIONS