Installation Guide

PORTSMOUTH™

Certiﬁed to comply with ASME A112.18.1M

Installation

Instructions

4285.501

4285.501F15

DUAL CONTROL KITCHEN FAUCET

SINK OR

MOUNTING

SURFACE

(HAND TIGHTEN)

INSTALL FAUCET

INSTALL SPRAY

Place FAUCET (1) in postion on sink or mounting surface.

Assemble and tighten LOCKNUTS (2) from underside of

sink or mounting surface. Hand tighten to secure FAUCET (1).

FAUCET (1) can be installed with or without HAND

SPRAY (3). To install FAUCET (1) with HANDSPRAY (3)

thread PIPE CAP (4) counter-clockwise and remove.

Place the HOLDER (5) into the appropriate mounting

hole. Assemble the SPRAY HOLDER WING NUT (6)

onto the shank of SPRAY HOLDER (5) from below

and hand tighten.

Feed SPRAY HOSE (7) through HOLDER (5) so SPRAY (3)

sits in HOLDER (5).

From underneath sink, attach COUPLING NUT (8) of SPRAY

HOSE (7) to HOSE SHANK (9). Tighten COUPLING NUT (8)

ﬁrmly.

M965458 Rev. 1.3

INSTALL FAUCET and SPRAY

Turn off water at

main supply.

CAUTION

RECOMMENDED TOOLS

Plumbers' Putty or Caulking

Adjustable Wrench

Channel Locks

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

PAGE 1
PORTSMOUTH™ Installation Instructions 4285.501 4285.501F15 DUAL CONTROL KITCHEN FAUCET Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ASME A112.18.1M M 9 6 5 4 5 8 R e v. 1 .
PAGE 2
MAKE WATER SUPPLY CONNECTIONS NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE PURCHASED SEPARATELY. 1 1 Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use adjustable wrench to tighten connections. Do not over tighten. For BULL-NOSE RISERS (3), be careful not to kink copper supply when bending. Use of tubing cutter may be required to cut to proper length.
PAGE 3
PORTSMOUTH™ DUAL CONTROL KITCHEN FAUCET MODEL NUMBER 4285.501 4285.501F15 M909933-YYY0A KNOB M962285-YYY220A (2.2 GPM) SPOUT KIT M962285-YYY150A (1.5 GPM) SPOUT KIT M909610-YYY0A INDEX BUTTON 918555-0070A HANDLE SCREW M917136-0070A SET SCREW M923825-YYY0A (2.2 GPM) AERATOR M922881-YYY0A (1.