Installation Guide

- 3 -
6
7
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
5
M985012 (3/19)
1
3
2
4
5
REMOVE
COLD
ON
OFF
HOT
SERVICE
1
2
3
5
7
5a
4
6
TEST INSTALLED FAUCET
• Move HANDLE (1) into “off” position.
• Turn on water supplies.
• Check connection for leaks. (See Section 4)
• With HANDLE (1) in “off” position, unthread
SPRAY (3) from HOSE (2).
• Operate handle back to front, in COLD
and HOT positions, to ush water lines
thoroughly.
• Replace SPRAY (3) onto HOSE (2).
If Faucet Drips, Proceed As Follows:
• Turn VALVE to OFF position.
• Operate HANDLE several times from OFF to ON position. Do not apply excessive force.
Reduced Flow:
• Clean out spray head screen.
• Clean out cartridge.
Clogged CARTRIDGE outlets or inlets may
cause reduced flow.
To clean, rst turn off water supply then:
• Loosen HANDLE SCREW (1) and remove
HANDLE (2).
• Unthread ESCUTCHEON CAP (3),
SNAP RING (4).
• Lift CARTRIDGE (5) off MANIFOLD (6) and
remove CARTRIDGE SEALS (7).
• Clean MANIFOLD (6), CARTRIDGE (5)
ports and SEALS (7).
• Place SEALS (7) into CARTRIDGE
PORTS (5a).
• Place CARTRIDGE (5) onto
MANIFOLD (6).
• Replace ESCUTCHEON CAP (3), SNAP RING (4),
HANDLE (2), tighten HANDLE SCREW (1).