Specification Sheet

ALCOVE SHOWER BASE
HIGH GLOSS ACRYLIC
ALCOVE SHOWER BASE
Product Features:
• Acrylic with fiberglass reinforcement
• Single threshold unit
• Textured bottom pattern
• Integral three-sided, double tiling edge
with water retention flange
• Molded-in flood guard
• PVC shower drain with stainless steel
drain plate
❏ 4242.ST ALCOVE SHOWER BASE
Nominal Dimensions: 1070 x 1070 x 168mm
(42-1/8" x 42-1/8" x 6-5/8")
❏ 3636.ST ALCOVE SHOWER BASE
Nominal Dimensions: 914 x 919 x 168mm
(36" x 36-3/16" x 6-5/8")
❏ 3232.ST ALCOVE SHOWER BASE
Nominal Dimensions: 813 x 813 x 168mm
(32" x 32" x 6-5/8") Does not meet IAPMO
minimum inside square inch requirements of
1,024 square inches.
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ANSI Z124.2 for Plastic Showers
• ASTM E162 for Surface Flammability
• NFPA 258 for Smoke Density
© 2002 American Standard Inc.
BV-045
SPS 4242./3636./3232.ST
To Be Specified - Required:
❏ Color: (specify color)
To Be Specified - Optional:
❏ Metal Drain Plate in Polished Brass or Satin
(751819-099)
❏ Satin (751819-295)
NOTES: REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH SHOWER
BASE FOR ADDITIONAL INFORMATION.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of
tolerances established by ANSI Standard Z124.1 / CSA. These measurements are
subject to change or cancellation.
No responsibility is assumed for use of superseded or voided pages.
Revised 3/02
See reverse side for roughing-in dimensions