Specification

ManualsBrandsAmerican Standard ManualsBar FaucetsBeale Single-Handle Pull Down Bar Faucet in Stainless Steel

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

M965685 Rev. 1.0 (4/16)

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

BEALE

™

MANUAL PULL-DOWN

KITCHEN & BAR FAUCETS

INSTALLATION

INSTRUCTIONS

4931300

4931410

Flat Blade Screwdriver Adjustable Wrench Plumbers’ Putty or CaulkingPhillips Screwdriver

Certied to comply with ANSI A112.18.1M

B (OPTIONAL)

SPOUT BASE

SINK OR

MOUNTING

SURFACE

SPOUT BASE

CAUTION

Turn off water at

main supply

(A) Installation less DECK ESCUTCHEON

• Make certain the SEAL (2) is properly seated in bottom recess of MOUNTING RING (10) and SEAL (12) in top recess of

MOUNTING RING (10). Insert supply HOSES (3), SPRAY HOSE (4) and SHANK (5) through mounting hole and seat SPOUT

BASE onto sink or mounting surface. Do not use putty.

• Insert HOSES (3) through RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8).

• Assemble RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8) onto SHANK (5) from underside

of sink or mounting surface. Hand tighten LOCKNUT (8).

• Use a screwdriver to tighten SCREWS (9) on LOCKNUT (8). Work your way around LOCKNUT (8), tightening the screws

slightly each time until all are snug to ensure even pressure.

(B) Installation with DECK ESCUTCHEON (optional)

• Make certain the SEAL (12) is properly seated in top recess of DECK ESCUTCHEON (1) and SEAL (13) is properly seated

in bottom recess of DECK ESCUTCHEON (1). Do not use putty.

• Screw in two THREAD RODS (14) onto bottom of DECK ESCUTCHEON (1).

• Insert SUPPLY HOSES (3), SPRAY HOSE (4) and SHANK (5) through hole of DECK

ESCUTCHEON (1), and mounting surface.

• Follow mounting instructions above

to secure faucet to mounting surface.

Thread the MOUNTING NUTS (11) to

secure DECK ESCUTCHEON.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS BEALE™ 4931300 4931410 MANUAL PULL-DOWN KITCHEN & BAR FAUCETS Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS • Turn off hot and cold water supplies before beginning. • Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply hose (Red Stripe) to Hot wall supply. Connect right supply hose (Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 1 * Faucet supplies are 35" long from faucet base.
PAGE 3
5 TEST INSTALLED FAUCET • Turn ON water at main supply. • With HANDLE (1) in “off” position, unthread SPRAY (3) from HOSE (2). • Operate handle back to front, in COLD and HOT positions, to flush water lines thoroughly. • Replace SPRAY (3) onto HOSE (2). 2 3 1 REMOVE 6 SERVICE If Faucet Drips, Proceed As Follows: • Turn VALVE to OFF position. • Operate HANDLE several times from OFF to ON position. Do not apply excessive force. Clogged CARTRIDGE outlets or inlets may cause reduced flow.
PAGE 4
BEALE™ MANUAL PULL-DOWN KITCHEN & BAR FAUCETS MODEL NUMBER 4931300 4931410 M964451-YYY0A SPRAY WITH HOSE (BAR) M951483-0070A CARTRIDGE M964450-YYY0A SPRAY WITH HOSE (PULL-DOWN) M918511-0070A CARTRIDGE SCREWS M922372-0070A AERATOR KEY (PULL-DOWN) M922383-0070A AERATOR KEY (BAR) M964453-YYY0A HANDLE KIT M964452-YYY0A MOUNTING RING M907315-YYY0A ESCUTCHEON CAP A911897-0070A SEAL M962146-0070A MOUNTING KIT Replace the “YYY” with appropriate finish code POLISHED CHROME 002 STAINLESS STEEL 075 M96445