Installation Guide

3
M965652 Rev. 1.9 (3/19)
Fig. 1a
1
5
2
4
3
3
SENSOR
CABLES
6
6
5
5
Fig. 1b
Fig. 2
1
2
3
4
5
6
7
10'
Roughing-in Dimensions
Fig. 1
RECOMMENDED TOOLS
1. Slip Joint Pliers
2. Adjustable Wrench
3. Plumbers’ Putty or Caulking
4. Phillips Screwdriver
5. Flat Blade Screwdriver
6. Electric Drill & 1/4" Drill Bit
7. Tape Measure
1. Installation Instructions
2. Spout Assembly
3. Mounting Nuts
4. Control Box
5. Supply Hose
6. Mixing Valve (optional, must be ordered separately)
7. Control Box Cover Screws
GENERAL DESCRIPTION
Electronic faucet with proximity operation. Vandal
resistant solid brass construction single post mounting.
Operates on DC (battery/power pack) or AC permanent
power (plug-in/hardwire). In-line strainer for solenoid
is integral. Single inlet 3/8 compression, built-in check
valves, and exible stainless steel 16-1/4" reach inlet
hose for spout connection.
Note: All plumbing and electrical wiring must be
installed in accordance with applicable codes,
regulations and standards.
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any
components will void the warranty.
1
INSTALL SPOUT ASSEMBLY;Fig. 1
1. Make sure PUTTY PLATE (1) is installed on
FAUCET BODY (2). Fig. 1a.
2. Insert CABLES (3), FLEX HOSE (4) and STUDS (5)
through holes of mounting surface. Fig. 1a.
3. From underside of mounting surface, install SPIN
NUTS (6) onto MOUNTING STUDS (5). Fig. 1b.
4. Align FAUCET (2) and hand tighten SPIN NUTS (6)
to secure faucet to mounting surface. Fig. 1b.
CAUTION
Turn off hot and cold water
supplies before beginning.
FAUCET INSTALLATION
381mm
(15)
155mm
(6-1/8)
102mm
(4)
38mm
(1-1/2)
MAX.
124mm
(4-7/8)
114mm
(4-1/2)
500mm
(20")
3/8" COMP.
125mm
(4-7/8)
81mm
(3-3/16)
MOUNTING
SURFACE
FINISHED
WALL
175mm
(6-7/8)
162mm
(6-3/8)
35mm
(1-3/8)
DIA.
3 HOLES
108mm
(4-1/4)
57mm
(2-1/4)
RECOMENDED ELECTRICAL BOX OR
EQUIVALENT BY OTHERS
HARD-WIRED AND MULTI AC 10’ MAX. CABLE LENGTH
4" (102mm) SQ. X 3-1/2" (89mm) DEEP ELECTRICAL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).