Installation Guide

M965650 Rev. 1.6 (10/16)
4
1. Remove CONTROL BOX COVER (1). Fig. 1.
2. Feed the 27" EXTENSION CABLES (2) through the
top of CONTROL BOX (3). Fig. 1a.
FOR STANDARD BATTERY VERSION ONLY
3. Insert BATTERY (4) into BATTERY HOLDER (5),
make sure the shape of the BATTERY (4) follows the
shape of the BATTERY HOLDER (5) and terminal
end is inserted first. Fig. 1b.
4. Insert the BATTERY CONNECTOR (5a) from the
Standard Battery or PWRX Battery Pack through side
GROMMET (6) as shown. Fig. 1c
5. Connect SOLENOID CABLE (7) and BATTERY
CONNECTOR (5a) to 27" EXTENSION CABLES (2).
Place Standard Battery or PWRX Battery Pack into
housing. Fig. 1d.
6. Replace CONTROL BOX COVER (1). Tighten cover
screws firmly.
DC VERSIONS (PWRX &
STANDARD BATTERY); Fig. 1
A
Fig. 1a
Fig. 1b
Fig. 1
2
3
1
4
5
INSTALL BATTERY
CR-P2
5a
5
CAUTION: Use only American Standard supplied
cable sets. Using non-AS supplied cables, or
cutting, splicing or modifying any components will
void the warranty.
ELECTRICAL INSTALLATION
Fig. 1c
7
2
STANDARD
BATTERY
PWRX
5a
5a
6
STANDARD
BATTERY
PWRX
Fig. 1d
5a
Product Page
Plug-in AC Power Kit
(PK00.PAC)
5
Hard-Wired AC Power Kit
(PK00.HAC)
5
MULTI-AC Power Kit
(PK00.MAC)
6