Installation Guide

1
7301407-100 Rev. A
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2013
Drain Tube
Flange Coupler
Wall Bracket
(6154.100, 6155.100)
Wall Bracket
(6150.100)
Rubber Gasket
Screws, wall anchors, washers
Drain Insert
Drain Must Have Standard Urinal Flange.
(Not Supplied)
Key
Odor Barrier
NEW CONSTRUCTION
6150.100 6154.100 & 6155.100
6150.100 6154.100 & 6155.100
6150.100
6154.100
6155.100
1
3
7
2
BEFORE REPLACEMENT URINAL
INSTALLATION PLEASE
4
6
5
INSTALLATION INSTRUCTIONS
WATERLESS URINAL 6150.100, 6154.100, 6155.100
Shut off and cap water supply.
Remove existing hardware, caulk and grout.
Remove all hidden traps and conventional
siphons.
SNAKE the sewer line thoroughly.
Check for PROPER VENTING.
ENSURE PROPER DRAIN PITCH to ensure
water flows from the Urinal.
IF TEMPLATE NOT
AVAILABLE:
Hold the bracket flush
with the back of the
urinal. Measure from the
bottom of the bracket to
the middle of the drain
pipe on the Urinal. Using
this measurement,
measure from the middle
of the drain pipe in the
wall and mark the spot.
Remove old rubber gasket and
clean flange and drain thoroughly.
Install NEW FLANGE COUPLER,
rubber gasket with longer part
towards the wall and tighten bolts.
Install the wall bracket. Make sure
the bracket is level and centered.
Lubricate drain tube and insert into
coupler. Run in and out until this
can be done easily.
Grab drain tube with a plier or
similar tool and put into housing
until it hits the stop about 1-1/4"
in depth.
CAUTION: DO NOT use pipe dope
or plumber’s putty - will cause
housing failure. Warranty is void
if plumber’s putty or pipe dope is
used for the housing connection.
Perform a water test for a good
flow and verify there are no leaks.
Secure Urinal on the bottom.
Perform set-up following the
set-up instructions.
Finish installation by caulking
around the bowl.
Hang the Urinal.
Check for pitch and alignment to
waste line pipe. Adjust Wall Bracket
up or down as needed for proper
drain line pitch and alignment.
Not recommended to install on any copper plumbing.
CAUTION: DO NOT use pipe dope or plumber’s putty - will cause housing failure.
Warranty is void if plumber’s putty or pipe dope is used for the housing connection.
Before installing the Urinal, make sure
drain line is clean and clear of debris.

Summary of content (4 pages)