Installation Instructions

4
2
1
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
5
2
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
12
“P” TRAP
WASTE
OUTLET
4
CARE INSTRUCTIONS:
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
M965624
3
10
AERATOR (10) may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR (10) and rinse to clear any debris.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
90˚
90˚
11
SERVICE
To change direction of handle:
6
10
7
1
2
3
4
RED
5
BLUE
8
9
9
Turn valves to OFF position.
Turn off water supplies.
Loosen SET SCREW (1) with 5/64" HEX WRENCH (2).
Pull HANDLE (3) “UP” firmly to release from
PLASTIC INSERT (4, 5 or 6).
Remove SCREW (7) and pull off PLASTIC INSERT
(4, 5 or 6).
Remove RETAINING O-RING (8).
Lift and turn STOP WASHER (9) 90˚.
Replace RETAINING O-RING (8).
Re-install HANDLE ASSEMBLY.