Installation Guide
Connect TEE (1) to SPOUT SHANK (2). Tighten COUPLING
NUT (3).
Connect COUPLING NUTS (4) of HOSE to each valve outlet and
tighten securely.
3
TEE AND HOSE INSTALLATION
1
3
2
4
4
3
MAKE WATER SUPPLY CONNECTIONS
Connect water supply to FAUCET (1) with 1/2" IPS
FLEXIBLE SUPPLIES (3) or 3/8"
O.D. BULL-NOSE RISERS (4).
Use adjustable wrench to tighten
connections.
Do not over tighten.
Be careful not to kink
copper supply when
bending. Use tubing
cutter to cut to proper
length.
1
4
FERRULE
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
COUPLING
NUT
VALVE
OUTLET
HOSE
6
Push INDEX CAP (4) in hole of LEVER BALL (6).
Secure HANDLE BASE (2) with HANDLE SCREW (3).
INSTALL POP-UP DRAIN
INSTALL HANDLES (LEVER)
5
1
2
A
3
4
5
10
11
12
8
G F
D
E
6
7
F
C
9
Push Tail piece (11) down into Trap (C) (threaded end up).
Assemble Pivot Rod (9) as shown in Figure-4B. Notice the
position of the Concave Washer (G).
Insert Pivot Rod (9) into Drain Body (10) and tighten Pivot
Nut (F).
Thread Locknut (5), Washer (4) and Gasket (3) (Bevel side
up) onto Drain Body (10).
Apply a bead of Putty (D) to underside of Flange (2).
Remove one end of Clip (8) from Pivot Rod (9) by squeezing
ends together while sliding.
Insert Pivot Rod (9) into second or third hole in Extension
Rod (7) and reassemble Clip (8).
Adjust stopper height by repositioning Extension Rod (7) and
tightening Thumbscrew (6).
Feed Drain Body (10) up through Sink (A) and thread the
Flange (2) fully onto Drain Body (10).
Tighten Locknut (5) firmly, keeping the pivot rod hole pointed
towards the back of the sink.
Drop Stopper (1) into Drain Body (10).
Position Extension Rod (7) onto Pop-Up Rod (E) and tighten
Thumbscrew (6).
1-1/4"
"O" RING
FIGURE-4B:
Push TAILPIECE INSERT (12) into TAILPIECE (11) and push
TAILPIECE up and thread tightly into DRAIN BODY (10).
1/2" IPS
FLEXIBLE SUPPLIES
3/8 O.D.
BULL-NOSE RISERS
1
2
5
3
4
6
Turn VALVE into OFF position.
Push ADAPTER (1) into HANDLE BASE (2) in a way that the male square on the
ADAPTER (1) fits in the female square of the HANDLE BASE (2).
Push HANDLE BASE (2) and ADAPTER (1) onto VALVE STEM (5).
Check alignment, if not satisfactory aligned;
Push out ADAPTER (1) carefully.
Turn ADAPTER (1) either 45˚ or 90˚so that male square on ADAPTER (1)
catches different female square in HANDLE BASE (2).
US60404E