Installation Guide

ManualsBrandsAmerican Standard ManualsShower DoorsAM3838N1400.020

710351-100 Rev. B 6/16

Product names listed herein are trademarks of AS America Inc.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed

properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure

your installation conforms to local codes.

INSTALLATION INSTRUCTIONS

AXIS 72 x 38 NEO ANGLE SHOWER DOOR

MODEL: AM3838N1400 SERIES

SAVE FOR FUTURE USE

REQUIRED TOOLS AND MATERIALS

GENERAL INFORMATION

Please inspect the product immediately upon receipt for transit damage, missing packs/parts or manufacturing

fault. Damage reported later cannot be accepted. Please handle the product with care avoiding knocks and

shocks, or loading to all sides and edges of the glass.

IMPORTANT: TEMPERED GLASS CANNOT BE DRILLED, CUT OR MODIFIED.

READ THE INSTRUCTIONS CAREFULLY

Familiarize yourself with all the parts as shown in the assembly drawing. The assembly drawing will also

provide a helpful reference when relating the location of the various parts and how they are mounted.

Special care should be taken when drilling walls to avoid hidden pipes or electrical cables.

Note: This product is heavy and may require two people to install.

For product quality or installation issues, we would like to hear from you.Please do not hesitate to call

American Standard at 1-800-442-1902 and follow the prompts for consumer/shower doors.

AFTER-CARE INSTRUCTIONS

After use, your shower should be cleaned with soap and water. This is particularly important in hard water

districts where insoluble lime salts may be deposited and allowed to build up. Cleaners of a gritty or abrasive

nature should not be used. Care should be taken to avoid contact with strong chemicals such as organic

solvents and strippers.

Glass cleaners can be used, but with caution; if in doubt, contact the manufacturer of the cleaner in question.

Please keep these instructions for aftercare and customer service details.

Step Ladder

Regular Screwdriver

Phillips Screwdriver

10'

Caulking Gun & Silicone

Drill 1/4" & 1/8" Drill Bits

#2 Square Drive Bit

Tape Measure

Level

Hammer

Pencil

Utility Knife

Safety Glasses

Summary of content (9 pages)

PAGE 1
INSTALLATION INSTRUCTIONS AXIS 72 x 38 NEO ANGLE SHOWER DOOR MODEL: AM3838N1400 SERIES Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
PAGE 2
BOX CONTENTS 2 Wall Posts 2 Corner Posts INSTALLATION INSTRUCTIONS AXIS 72 x 38 NEOANGLE SHOWER DOOR MODEL: AM3838N1400 SERIES Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
PAGE 3
ASSEMBLY DRAWING [12] [11] [1] [2] [3] [4] [10] [5] [6] [9] [8] [7] [1] 8 Wall Anchors/Plugs [2] 8 Screws M4x35 [3] 24 Screw Cover Caps [4] 2 Wall Posts [5] 16 Screws M4x10 [6] 2 Fixed Panels [7] 2 Door Bottom Gaskets [8] 12 Screws M4x12 [9] 1 Door Panel [10] 2 Corner Posts [11] 2 Top Corner Caps [12] 2 Wall Jamb Caps 3 7 10 3 5 1- 10 0 Rev.
PAGE 4
INSTALLATION NOTES: This unit is best installed by two people. Cover drain with tape prior to installation to prevent the loss of small parts. Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using instruction sheet as a reference. Before discarding the carton check to see that no small hardware parts have fallen to the bottom of the box. If any parts are damaged or missing refer to the description noted in the instructions when inquiring about replacements.
PAGE 5
2 ASSEMBLING FIXED PANELS AND CORNER POSTS 1. Insert the Fixed Panels [6] into the wall posts. 2. Attach the Corner Posts [10] to the fixed panels with the hole facing the inside of the enclosure and secure using the M4x12 screws [8]. 1 1 2 1A 1B 2 VIEW FROM INSIDE 2A 3 FLAT SCREW M4x12 2B ASSEMBLING DOOR PANEL 1. Insert the Door Panel [9] into the corner posts. 2. Using a 1/8" drill bit, drill holes in the door panel using the holes in the corner posts as location guides.
PAGE 6
4 INSTALLING WATER DEFLECTORS/GASKETS 1. Install the Door Bottom Gaskets [7] on the bottom of the door as shown. Be sure that the gaskets extend from the door pivot to the end of the door. Some trimming of the gaskets may be required. 1A 1B 1 5 NOTE: Ensure that the fixed panels are plumb. Adjust the enclosure to be square and plumb. The enclosure should be adjusted to square the door and ensure it opens smoothly. FIXING THE ASSEMBLY TO THE WALL POSTS 1.
PAGE 7
6 INSTALLING TOP CORNER CAPS 1. A - C Place the Top Corner Caps [11] on the top of the corner posts. Using a Step Ladder will be helpful for this step. Mark the hole locations and drill holes in the tops of the door and fixed panels using a 1/8" drill bit as shown. Secure the Top Corner Caps using the M4x12 Screws and Washers. Place Screw Cover Caps over the screw heads.
PAGE 8
MAINTENANCE: Two primary materials are used to manufacture your new American Standard shower enclosure: tempered glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel after each use. For occasional, more concentrated cleaning efforts Lysol Non-Abrasive Bathroom Cleaner works extremely well. Be sure that any over spray falling on the aluminum frame is rinsed thoroughly and dried.
PAGE 9
PARTS SHOWER DOORS AXIS 72" x 38" NEO ANGLE SHOWER DOOR MODEL NUMBER: AM3838N1400 SERIES 1 4 2 3 6 5 7 NO. DESCRIPTION PART # FINISH QTY/UNIT 1 Pivot with Screw— 2 pieces 710366-101.0200A White 1 Set 2 Door Panel Side Gasket 710367-101.0070A N/A 1 Piece 3 Door Bottom Gasket 502 mm, 53 mm — 1 for each 710368-101.0070A N/A 1 Set 4 Wall Jamb Cap — 1 Left, 1 Right 710369-101.0200A White 1 Set 5 Top Corner Cap with Screw — 2 pieces 710370-101.