Use and Care Guide

710013-100
2
1
3
INSTALLATION PROCEDURES:
Place center threshold part #8104 on center of base. Drill
into base through guide holes with #29 or 1/8" bit and
attach using 8 x 5/8" flathead screws.
Measure from wall to outside edge of center threshold.
Repeat on opposite side, then cut each end.
Return and mark holes. Drill w/1/8" bit. Clean and caulk
underside at wall and joint.
Position stationary panels temporarily into wall trim. Place
corner posts on each panel.
Select side for hinge jamb. Place strike jamb into opposite
corner post. Set door in place temporarily.
4
With door in place, ensure panels and door are plumb
with threshold.
Measure from wall to corner post on both sides. Cut
bottom trim. (Do not cut mitered end.)
For best results use a 32-tooth hacksaw blade and a
miter box.
2
Set #5879 on top of threshold with mitered end down.
Plumb and mark holes. Repeat on opposite side.
Drill all holes with 1/8" for fiberglass and 3/16" masonry for
tile. Insert wall plugs and secure with 8 x 1" flathead screws.
NOTE: When drilling into fiberglass or plastic walls DO
NOT USE screw anchors.
8104
5879
CAULK
CENTER
OF
THRESHOLD
A
B
C
CORNER POST