Installation Guide

- 2 -
Figure 1.
Figure 2.
2
PLASTER
GUARD
1
4
1
3
OFF
1
M965762 (8/16)
• Figure 1. Remove plaster guard from valve. Push
CAP (1) over VALVE CARTRIDGE (2) until seated
against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and
attach to valve body with LONG SCREWS (4).
INSTALL VALVE TRIM
2
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip TUB SPOUT (1) onto tub nipple and tighten with
2.5 mm Hex Wrench.
CAUTION: Protect finish on TUB SPOUT when
installing.
• Install SHOWER ESCUTCHEON (2) onto SHOWER
ARM (3). Apply sealant or Teon tape to threads on
both ends of SHOWER ARM (3) and thread longer
leg of SHOWER ARM (3) into shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
• Slip ADAPTER (5) onto CARTRIDGE (6) and thread
SCREW (7) on.
CAUTION
Protect finish on SHOWER HEAD
and TUB SPOUT when installing.
PIPE
PLUG
4
3
2
SHR.
ELBOW
TUB FILLER
NIPPLE
5
7
1-1/2" REF.
2.5 MM HEX
WRENCH
6
1
OFF