Installation Guide

ManualsBrandsAmerican Standard ManualsBathTown Square 1-Handle Shower Faucet Trim Kit in Satin Nickel (Valve Not Included)

TOWN SQUARE

Recommended Tools

Adjustable Wrench Channel LocksFlat Blade Screwdriver Plumbers' Putty or CaulkingPhillips Screwdriver

1-5/8" TO 3-1/4"

FINISHED WALL

BOTTOM OF

TUB

74" FOR

HEAD CLEARANCE

2" REF.

18"

OPTIONAL

1/2" I.P.S.

7-5/8"

4-7/8" REF.

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65'' AND 78''

8" REF.

8-1/2" REF.

TOP OF

TUB RIM

1-3/4" REF.

1/2" COPPER

SEE VALVE INSTRUCTIONS FOR

INSTALLATION INFORMATION

7-1/4" REF.

Certiﬁed to comply with ANSI A112.18.1

T555.52X

Installation

Instructions

ROUGHING-IN DIMENSIONS

■ To assure proper positioning in relation to

wall, note roughing-in dimensions.

PRESSURE BALANCING BATH

AND SHOWER TRIM KIT

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

M965112 REV.1.4 (8/15)

FLOWISE 3-FUNCTION

SHOWERHEAD

Summary of content (4 pages)

PAGE 1
Installation Instructions TOWN SQUARE ® T555.52X PRESSURE BALANCING BATH AND SHOWER TRIM KIT Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1 Recommended Tools Phillips Screwdriver Flat Blade Screwdriver ROUGHING-IN DIMENSIONS ■ To assure proper positioning in relation to wall, note roughing-in dimensions.
PAGE 2
1 3 INSTALL TRIM CAUTION: Protect finish on SHOWER ARM, SHOWER HEAD and TUB SPOUT when installing. INSTALL HANDLE and TEST FITTING When finished tiling the wall, remove PLASTER GUARD (A) and turn off water supply. Align and install HANDLE (1) onto valve stem. Tighten SET SCREW (2) using 2.5mm Hex Wrench supplied. Push in index (4). Push CAP (1) over VALVE CARTRIDGE (2). Check proper operation of HANDLE (1). Mount ESCUTCHEON (3) to valve body with SCREWS (4).
PAGE 3
4 SERVICE TO GAIN ACCESS TO VALVE FOR SERVICING Turn off hot and cold water supplies. 7 Loosen HANDLE SET SCREW (1) and pull of HANDLE (2). If installed, pull off DECORATIVE SCREW COVER (3). 5 Remove two SCREWS (4) holding ESCUTCHEON (5) and remove ESCUTCHEON (5). Remove CAP (6). 6 3 4 VALVE LEAKS WHEN SHUT OFF Remove CARTRIDGE (7) by removing CARTRIDGE SCREWS (8). Remove three SCREWS (9) from FIXATION RING (10) and pull out PRESSURE BALANCING (16) unit. Clean SEALS (11) on base of CARTRIDGE (7).
PAGE 4
TOWN SQUARE® BATH/SHOWER TRIM KIT MODEL NUMBER T555.52X A901428-YYY0A SHOWER ARM 1660.813-YYY0A 3-FUNCTION FLOWISE SHOWER HEAD (T555.527/T555.528) M953570-YYY0A SHOWER HEAD (T555.521/T555.