Installation Guide

6
For circular cut outs, a circular electroplated diamond core bit must be used with a variable speed grinder or drill.
For straight line cut outs, a variable speed grinder with electroplated diamond blades must be used. Relief holes
or cuts before planning a square or rectangular shape are necessary.
When possible, it is best to fabricate niches and holes after the panel is already installed with thin set on wall or
floor. If it is not possible to cut holes or square/rectangular cuts (fireplace, sink, etc.)before the panel is installed,
create full support with plywood or MDF panel template with same shapes and cuts to attach and transport the
porcelain panel. Support panels should only be detached when porcelain panels are fully bonded to the substrate.
It is also possible to move panels with proper moving tools made of multiple suction cups to avoid tension of the
panel after it is cut.
Example of initial drawing for plumbing fixtures cut out Image shows use of drill with electroplated
diamond core bit.
Example of variable speed grinder using diamond
electroplated blade to make straight line cut out
Clean cut out complete
IT IS IMPORTANT TO AVOID STRESS AND TORSION TO THE ALREADY CUT PANEL.
GENERAL INSTRUCTIONS CONTINUED