Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-5
A - INTRODUCTION
4 to 20
in 8,0 mm
Cut before (CB), cut after (CA), no cut (OFF)
See section D 3.3
2,1 mm (± 0,3 mm electronic); 2,7 mm ( ± 0,3 mm electronic)
0,55 MPa = 80 PSI
530 mm (height) x 370 mm (width) x 560 mm (depth)
730 mm (height) x 1100 mm (width) x 700 mm depth) + 150 mm distance
64 kg
175 kg
1NPE~60Hz 230 V/TN/S; 1NPE~50Hz 230 V/TN/S
Min. 10A Characteristic C (EN60947-2)
L =86,9db; L =74,8 db; Noise measurement according to EN ISO 3746:1995
wA pfA
according to IEC 364-3, IEC 364-5-51 temperature from +5°C to 40°C, relative air humidity from 30 to 8 0%
1000 to 2000 stitches/min (500 to 1000 rev/min of the drive shaft)
0,5 to 2,0 mm (increments of 0,1 mm)
Sewing speed
Stitch Density
Buttonhole style
Eye type
Flybar length
Length of the cross bar
Number of stitches in the eye
Number of stitches in the round end
Clamp foot height (max)
Maximum work thickness
Buttonhole Cutting Mode
Cutting Space
Cut position (Y axis)
Bedplate movement
Needle system
Recommended threads*
Upper thread trimming
Lower thread and gimp trimming
Cutting space
Operating Condition
Air pressure
Machine db Level
Machine Head Dimension
Machine Head Weight
Table Dimensions
Machine Weight
Electrical requirements
Line Circuit Breaker
Bite Range Elecctronic
The length
of hole
L
= 3 to 7 mm
Cross bar density
8 to 60
1,5 to 2,5 mm
12 mm 5 mm
- 0,50 to + 1,2 mm
4-6 mm 4-8 mm
0,5 - 1,5 mm
No eye; 2,2 x 3,0 mm; 2,8 x 4,2 mm;
3,0 x 4,6 mm; 3,2 x 5,0 mm; 3,4 x 4,2 mm
± 1,5 mm
64 mm
62,5 mm
0.0558.1.112 (Nm 110) 0.0558.0.111 (Nm 100)
80, 100, 120, gimp size 30.
16 to 36 mm
L =
L
10 to 36 mm16 to 32 mm
RDELTTCT 16 - 32 mm
(short ends)
(long ends)
2 to 7 mm
23 to 27 mm
27 to 31 mm
31 to 35 mm
35 to 39 mm
L +3 to 7 mm
Machine type/model