Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-7
6. INSTRUCTIONS FOR OPERATOR SAFETY AND MAINTENANCE OF
THE MACHINE S-311
When installing the machine the manufacturer recommends the minimum clearance mentioned above
around the machine. Read all of the instructions that follow. DO NOT PUT THE MACHINE INTO
OPERATION UNTIL YOU ARE COMPLETELY FAMILIAR WITH ALL INSTALLATION AND
OPERATING INSTRUCTIONS.
DANGER!
- Before connecting the machine to the power supply, be positive that all safety covers are
correctly installed.
- Always engage the power lockout switch, and disconnect the main power supply, before
removing any safety covers.
- Never connect the machine to the power supply when any cover is removed.
- It is forbidden to disconnect all connectors when the machine is switched on and connected to
the power supply. The electrical components and motors can be damaged.
WARNING!
- Locate the Emergency Stop button. Be sure you know how to use it.
- Be sure that you have a reliable and uniform power supply.
- Be sure that all electrical cables are in good condition and have no signs of damage to avoid
electrical shock.
- If any covers become damaged, they must be repaired or replaced immediately.
- Do not touch moving parts of the machine while it is operating.
- Keep clear of the needle.
- Always switch off the main power before changing the needle.
- Before cleaning the machine or performing service to the machine, engage the power lock out
switch or disconnect the main power supply.
- When the machine is not in use engage the power lock out switch or disconnect the main
power supply.
A - INTRODUCTION