Service manual

S-311
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
1-10
2. TABLE ADJUSTMENT
2.1. fter you will unpack the machine, move the machine to its appointed place. The machine is
supplied with the stand with standart height for working in seat. For another stand
implementation is necessary to make an agreement with the customer. The recommended height
of the stand (table) is 870 mm. Tighten the screws Ë very well.
2.2. To stabilize the table, use the floor pads Ì, which are controlled by hand screw Í. Check the
levelness of the adjusted table.
2.3 Eliminate the shipping band Î, which holds the head in place. If transporting machine to a
different location, it is necessary to fasten the table to prevent shifting in transit.
1. CONTENT OF THE SHIPPING BOX
1.1. If it is not mentioned otherwise during ordering, the
shipping container usually contains:
— assembled machine on the stand with
electroinstalation
— box with the accessories
(specification in the spare parts
section)
— dis-assembled thread stand
ÊÊ
ÊÊ
Ê
— operation manual with the spare parts
manual
1.2. When unpacking the container, follow labels which are on a cover.
CAUTION: If the container was damaged during the transport, inform the carrier. Check the contents
of the container with order. In the event of an error, immediately inform the manufacturer- late
notification of an error in shipment may result in loss of claim.
ÊÊ
ÊÊ
Ê
B - MACHINE ASSEMBLY