Service manual

S-311
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
1-22
1. OPERATION
1.1. With the machine in the home position, before sewing, the manufacturer recommends 3 minutes
for warm up.
1.2. Be certain that the machine is threaded
correctly see section C3, and required
buttonhole appears on the display. Insert the
fabric under the clampfeet. Use the rear stops
Ê to position the buttonhole.
1.3. When the foot pedal Ë is pressed to the first
position, the fabric is clamped by the clamp
feet. (When the pedal is released, the clamp
feet rise.)
1.4. When the foot pedal is pressed to the its second
position, the sewing is started. When the buttonhole is sewn, fabric is cut and the upper thread
is trimmed, clamp feet rise and machine returns to its home position.
1.5. When the clamp feet are up, it is possible to move the fabric for sewing the next buttonhole.
1.6. Immediate stopping in any place of the cycle is possible by the EMERGENCY STOP
button Ì on the machine head. If the EMERGENCY STOP is released, the machine stops
(the flaw E01, see manual section - troubleshooting).
1.7. If the foot pedal Ë is pressed before the buttonhole is finished, the clamp feet will not rise. It is
possible to sew the buttonhole again after the foot pedal is pressed.
1.8. When your work is finished, switch off the switch Í , pull out the plug Î from the socket and
close the air supplyand close the air supply.
D - MACHINE CONTROLS
Ê