Service manual

S-311
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
1-32
D - MACHINE CONTROLS
ÊÊ
ÊÊ
Ê
ËË
ËË
Ë
Setting the number of buttonholes in the cycle - possible setting: 1-16 buttonholes
Note: If 0 is set, the machine starts to sew from the first set buttonhole.
Program number setting - range 0-9. If 0 (
ËË
ËË
Ë) is set, the cycle mode is not activated. After
the machine is switched on, the 0 automatically appears in the program number.
10. CYCLE MODE
It is possible to set the type and the number of buttonholes which will be sewn in one sewing cycle.
CAUTION:
Modification AF - it is necessary to use the same cutting length for all buttonholes in
one cycle. Imitation (no cut) buttonholes of different length can be included in the
sewing cycle.
Modification CT - to prevent the machine from damage, the length of buttonholes in one cycle must be
the same as the length of a cutting steel in the machine. To trim the lower threads, set the length of a
buttonhole according to the installed clamp feet - see section D3.
20
389
CT 20
Ready
100001 0
J
1
2
20
1000
01
1
0
2
3
4
6
7
8
9
5
5
CRL
ENT
20
389
CT
0
J
10
2 3 4
6 7 8 9
5
2 CRL
ENT
Veškeré naprogramované dírky a programy - zapsat, zapamatovat!!!