Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-33
D - MACHINE CONTROLS
12. MANUAL CUT MODE
The green button
ÊÊ
ÊÊ
Ê outside of the control box, activates cutting
independently of the program. It may be used with or without the fabric
clamps (closed by pressing the foot pedal to the first position).
Progress: Insert the fabric under the clamp feet, switch the foot pedal into
the first position, hold this pedal in this position and press button
ÊÊ
ÊÊ
Ê.
Cutting lever will cut the fabric everytime, when the button Ê is
pressed. Then release the foot pedal.
ÊÊ
ÊÊ
Ê
Example:
In the program number 5 you want to sew the buttonholes in the following order: 2, 1, 3, 4, 1.
1. To set the program number press the button
The numerical display appears on the screen. Choose program number 5 and press ENT.
2. Press button. The screen, where it is possible to set the order of sewn buttonholes, appears on
the display. Press the first number and using the numerical display set the buttonhole
number 2, which will be sewn as the first. Press ENT to confirm. Next, press the second
number to set the buttonhole number 1. Follow these steps to set all the buttonholes which will
be sewn. If 0 is selected, the cycle mode will return to the first set buttonhole (2).
3. Press to save the set buttonholes to program number 5. Return to the main screen .
4. Program number 5 and buttonhole number 2 appear on the display.
5. When the buttonhole is sewn,the number of the next buttonhole
in the cycle (1) will be displayed.
11. THE ELECTRONIC SYSTEM ERROR MESSAGES
If an error message appears on the display, press it
1
. The screen
2
with a description and a
correction of an error message appears on the display (see Troubleshooting).
E-01 axes aren´t home
press "H" button
Error
2
1
20
389
CT 20
E-01
100001 0
J
20
100001 5
J
20
100002 5
J
0
J