Service manual
S-311
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 03/2006
1-42
E - STANDARD MACHINE ADJUSTMENT
8.3. The knife in the axis X in the anvil ➏ loosing the screws ➎ and change safely the position,
to the right or to the left. Tighten the screws.
8.4. The knife stop in the anvil ➏ adjust for 70 mm after loosing the screws ➐.
8.5. The pressure of the pneumatic system is adjusted with the regulator Ñ for 0,6 MPa. This
pressure is suitable for all materials for cut lengths to 30mm. For difficult cut, increase the
pressute for 1/2 rotation anticlockwise.
8.6. The sensor ➒ on the cutting cylinder is adjusted approx. for 39 mm.
70 mm
64 -0,3 mm
Y
2122
2123