Service manual
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 03/2006
S-311
1-51
E - STANDARD MACHINE ADJUSTMENT
17. THE GIMP DRAW-OFF ADJUSTMENT - CT
The distance between the stop screw
ÊÊ
ÊÊ
Ê and the race is 14 mm. The length of the gimp
ÍÍ
ÍÍ
Í should be
4 mm after thread is trimmed. To change the length of the starting thread (gimp), loosen the nut
ËË
ËË
Ë
and rotate the screw
ÌÌ
ÌÌ
Ì. If the draw-off is too small, the thread will not be stitched. If the draw-off is
too big, there can be dirt in the machine after trimming.