Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-57
Caution: - Do not neglect periodic maintenance.
- If you have fault in electrical power supply, switch off the operating switch (circuit breaker).
- Do not damage, correct and remove safety labels.
- Do not work with the machine when you are under the influence of drugs or alcohol.
- User has to ensure the lighting of the working area minimal 750 Luxes.
1. CLEANING AND MAINTENANCE OF THE MACHINE
1.1. Switch the power off and disconnect the air
supply.
1.2. For cleaning and maintenance, remove the
clamp feet by removing the protecting
latches Ê. Lift the clamp feet and pull it to
the operator. Remove the locking screw Ì
and fold the rear cover Í.
1.3. Clean the thread lints and fabric from the
sewing area - guides and thread tension. To
move the sewing mechanism, turn the hand
wheel Ï. It is also possible to turn the race
by hand. The machine head can be raised to
the position where it is locked by a strut
which is controlled by a button Î.
By pressing the button Î, the machine can
lowered to the working position.
WARNING! Possible serious injury when
lowering the machine head.
1.4. Lubricate the machine according to the
section F4.
1.5. Check if the oil reservoir Ð, under the
machine, is full. It is necessary to liquidate
used oil according to the environment
regulation.
F - MACHINE MAINTENANCE






Warning: - Check electrical cables for damage.
- Check if the safety covers are in a good condition. Order or replace damaged covers.
- Keep your hands out from the needle space and cutting mechanism.
- Do not modify the machine in any way, which can eliminate its safety parts.