Service manual

Revised 11/2006
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
S-311+I
1-13 I
E - STANDARD INDEXER ADJUSTMENT
1. SETTING UP THE HEIGHT OF CLAMPING FEET
In order for the Indexer to function correctly, it is important to set up correct height of Indexer clamping
feet above the desktop.
1.1. Loose clamp holders screws
Ê on the left and right side of the Indexer.
1.2. Set up a gap of 0,5 - 0,7 mm between feet and desktop (feeler gauge can be used).
1.3. Verify the setting by pressing the button
. The device must move freely without stopping.
1.4. If the device stops, it is necessary to increase the gap between feet and desktop according to
instructions in 1.1, 1.2.
Note: The above-mentioned adjustment is necessary every time you change the distance between the
clamping feet according to the size of workpiece and number of buttonholes sewn.
Ê
0,5 - 0,7 mm