Service manual

Revised 11/2006
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
S-311+I
1-14 I
2. SETTING UP MINIMAL PLAY BETWEEN INDEXER FEET AND CLAMPING MAT
It is important to set up the minimal play between Indexer feet Ê and clamping mat Ë correctly so that
the spreading mechanism on the sewing head operates correctly. It is necessary to hold the minimal
play.
2.1. Check, whether the play on the machine is set onto 2mm in both positions of the Indexer. Use this
display button to make a move.
2.2. If the 2-mm distance is not adjusted on the
machine, loose screws
Ì and move sensors
Í into the required position. The distance
increases in the direction of A and decreases
in the direction of B.
2.3. Secure the setting by tightening screws Ì.
2.4. Check the setting by pressing the button
. The device must move freely without
stopping.
Note: If the distance is smaller than 2 mm,
the fabric will not be properly
stretched during sewing an eye!
E - STANDARD INDEXER ADJUSTMENT
Ë
Ê 2 mm
Í
Ì
Í
Ì
A
B
A
B