MICRO-CL Stack Owner’s Manual
MICRO-CL Stack TABLE OF CONTENTS What’s in the Box ��������������������������������������������������������������������������������������������� 2 Introduction ������������������������������������������������������������������������������������������������������� 2 Features ������������������������������������������������������������������������������������������������������������� 3 The Front Panel ������������������������������������������������������������������������������������������������� 4 The Rear
MICRO-CL Stack Features Amplifier: • Power output: 100 Watts at 8 Ω • Preamp: Solid-state • Power Amp: Solid-state • Tone Controls: Bass, Mid, Treble • Unbalanced Line Out • Effects Loop • Dual Inputs (0 dB and –15 dB) • 1/8" Headphone Out / Line In • Dimensions (H x W x D): 7" x 12.2" x 10" • Handling Weight: 13.8 lb / 6.
MICRO-CL Stack The Front Panel MICRO CL 0dB 1 1. 2. Input -15dB Master Treble Mid Bass Aux Level 2 3 4 5 6 7 0 dB INPUT: The signal output from a passive instrument may be connected to this 1/4" Input by means of a shielded instrument cable. –15 dB INPUT: The signal output from an active instrument may be connected to this 1/4" input by means of a shielded instrument cable. 3. MASTER: Use to control the output level of the instrument only.
MICRO-CL Stack The Rear Panel MICRO CL AC LINE IN SPEAKER EFFECTS LOOP CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT REMOVE CHASSIS (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. AVIS: RISQUE DE CHOC ELECTRIQUE- NES PAS OUVRIR. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 8 OHM ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
MICRO-CL Stack System Block Diagrams Amplifier Amplifier: LINE OUT TONE CONTROL CIRCUITRY Inputs 0 dB -15 dB Send Treble Bass Mid Volume EFFECTS LOOP Return AUX Inputs POWER AMPLIFIER SPEAKER OUTPUT 100 W Aux Level Phones MUTE Cabinet Speaker Cabinet: (2) 10" speakers Input 6
MICRO-CL Stack Technical Specifications Output Power Rating 100 Watts @ 8 Ω Signal to Noise Ratio 72 dB (20 Hz – 20 kHz, unweighted) Maximum Gain 59 dB at 1 kHz Amplifier Inputs 2 x 1/4" Jacks [0dB, –15dB] 2 x 1/8" Jacks [Aux, Headphones] Tone Controls Bass: +11/–11 dB @ 50 Hz Midrange: +11/–11 dB @ 600 Hz Treble: +13/–13 dB @ 6 kHz Power Requirements Japan: 100V ~50–60 Hz, 85W U.S.
MICRO-CL Stack Warranty and Support Visit WWW.AMPEG.COM to... (1) ...identify WARRANTY coverage provided in your local market. Please keep your sales receipt in a safe place. (2) ...REGISTER your product. (3) ...CONTACT Technical Support, or call 818-575-3600. www.ampeg.com Yamaha Guitar Group, Inc. 26580 Agoura Road, Calabasas, CA 91302-1921 USA Rev. A © 2019 Yamaha Guitar Group, Inc. All rights reserved. Ampeg, the Ampeg logo, and SVT are trademarks or registered trademarks of Yamaha Guitar Group, Inc.
