User Manual
Table Of Contents
4
MICRO-CL Stack
The Front Panel
1 2 3 4 5 6 7 8 9 10 11
TrebleMasterInput Mid Bass Aux Level
Aux
Input
-15dB0dB
On
PowerPhones
MICRO CL
1. 0 dB INPUT: The signal output from a
passive instrument may be connected
to this 1/4" Input by means of a
shielded instrument cable.
2. –15 dB INPUT: The signal output from
an active instrument may be connected
to this 1/4" input by means of a
shielded instrument cable.
3. MASTER: Use to control the
output level of the instrument only.
It aects the Speaker Output [13]
and Headphones Output [9]. Use it
wisely and turn it down when making
connections, putting on headphones, or
trying something new.
4. TREBLE: Use to adjust the high
frequency level of the amplier. This
provides up to 13 dB of boost, or 13 dB
of cut, at 6 kHz. The high frequency
output is at at the center position.
5. MID: Use to adjust the midrange
frequency level of the amplier. This
provides up to 11 dB of boost, or
11 dB of cut, at 600 Hz. The midrange
frequency output is at at the center
position. Rotate the control counter-
clockwise for a “contoured” sound
(more distant, less midrange output) or
clockwise for a sound that really cuts
through.
6. BASS: Use to adjust the low frequency
level of the amplier. This provides up
to 11 dB of boost, or 11 dB of cut, at
50 Hz. The low frequency output is at
at the center position.
7. AUX LEVEL: Use to control the output
level of the signal fed to the Aux Input
[8]. Use it wisely and turn it down
when making connections, putting on
headphones, or trying something new.
8. AUX INPUT: The audio output from line
level sources such as a mobile device
or MP3 player, can connect to this 1/8"
TRS stereo input. The incoming audio is
mixed with the preamp signals, so you
can play along to a practice track while
listening with headphones. (The audio
here appears in the cabinet speakers
until headphones are plugged in; then
heard in the headphones only).
9. PHONES: Use this 1/8" TRS stereo
output to connect headphones. The
output here is a mix of the line level
signals reaching the amplier, plus any
incoming audio from the Aux In jack [8].
Before putting on headphones,
make sure the Master control [3]
and Aux Level [7] are turned down.
This will reduce the chance of hearing
damage due to loud volumes.
Note: The speaker is muted when
headphones are plugged in.
10. ON LED: This LED illuminates red when
the power is on.
11. POWER SWITCH: Use this switch to
turn the overall system power on or o.
Press the top of the switch to turn on
the power, and press the bottom of the
switch to turn it o.