Operation Manual

Preparing the Equipment

Operating the vibration pad

In order to use the vibration pad, it must initially be fully charged:

1. Connect the alarm clock to the mains power supply via the

power adapter plug.

2. Remove the small rubber cap from the sliding switch on the

vibration pad.

3. Plug one end of the connection cable in the socket in the

vibration pad and in the other end in the socket for the

vibration pad in the alarm clock.

4. The LED on the vibration pad lights up red.

5. When the vibration pad is fully charged, disconnect the

connection cable from the alarm clock.

6. Use the sliding switch on the vibration pad to switch it on.

7. Set the alarm mode on the alarm clock to vibration" or

acoustic alarm + vibration".

On reaching the set time, the vibration pad vibrates

intermittently until the alarm function is interrupted by

pressing the Snooze button (1).

Using the telephone signal

You can also use the TCL 190 alarm clock to signal incoming

telephone calls. Connect the TCL 190 alarm clock to the

telephone connection socket as illustrated in the connection

diagram.

Each incoming call is then diverted to the alarm clock and the

acoustic signal is triggered by each call regardless of the alarm

time set.

0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge and then 5p a minute. Mobile costs may vary.)