Operation Manual

Settings and Functions
24
4 Settings and Functions
Setting the time
Use the rotary knob (15) to set the correct time.
Setting the alarm time
Use the rotary knob (14) to set the time at
which the alarm should be triggered.
Switching the alarm signal on and off
Activate or deactivate the alarm by turning the
rotary knob (3) on or off, respectively.
Anticlockwise Off" or clockwise On".
Setting the volume
The alarm and telephone ringer volumes start quietly and
increase to the maximum volume.
Set the alarm volume by turning the volume
rotary knob (4) to the required volume. First of
all, set the volume to a quiet setting and
increase it slowly.
Exposure to the alarm at full volume for a long
period could cause ear damage.
Selecting the acoustic signal
Turn the rotary knob (5) to set the required
acoustic signal.
Setting the pitch
Turn the rotary knob (3) to set the required
pitch for the acoustic signal.
Setting the clock face illumination
Move the sliding switch (10) to activate the
clock face illumination. The following settings
are available, from left to right (bright",
medium" or off").
Selecting the type of alarm (mode)
MODE
Move the sliding switch (7) to set the type of
alarm with which you want to be alerted. There
are three settings available, from left to right
(vibration only", acoustic signal only" or
acoustic signal + vibration").
Setting the flashing light
ON OFF
The sliding switch (8) is available with which to
select whether the flashing lamp in the Snooze
button should also be activated together with
the alarm signal set. Two settings are available,
from left to right On" or Off".
0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge and then 5p a minute. Mobile costs may vary.)